 Snap-Clad
SNAP-CLAD Panels feature architectural panel aesthetics as well as structural
panel performance. SNAP-CLAD Panels, produced in continuous lengths, are
corrective leveled to provide superior flatness and feature an optional
factory-applied sealant bead for improved weather resistance. Maximum
panel length is 64 feet and minimum panel length is 4 feet. SNAP-CLAD
Panels feature a 1-3/4” leg height and a continuous interlock
for improved structural performance and wind resistance. A concealed
fastener clip system allows for thermal expansion/contraction while
providing extraordinary hold-down strength. Two clips are available:
a standard clip for most mansard and fascia applications and a high-performance
clip for roofing application and UL 90 rated assemblies.
Trim
All flashing and trim will be fabricated by manufacturer or qualified
fabricator. Flashing shall be PAC-CLAD aluminum (.032-.063 gauge as
specified) or PAC-CLAD steel (24 ga. or 22 ga. as specified). A 20 year,
non-prorated finish warranty can be supplied covering finish performance.
Installation
SNAP-CLAD Panels are intended for use in roofing, mansard, and fascia
applications. Substrates may include 5/8” (min.) plywood, nailboard
insulation or equal with an underlayment of ice and water shield or
30# (min.) roofing felt applied horizontally from eave to ridge. Other
substrates may include metal decking, purlins or rigid insulation in
conjunction with bearing plates. A minimum 2:12 pitch is recommended
in most applications. Contact Petersen for detail assistance on projects
requiring lower slopes. For coastal applications, aluminum panels along
with stainless steel clips must be used for warranty. Consult a local
architect/engineer for compliance with local codes and conditions.
Eave Notching
Factory-produced eave notching is now available at
nominal additional cost on SNAP-CLAD Panels and Redi-Roof Standing Seam
Panels. Factory eave notching saves on labor cost by eliminating the
need for field cutting to produce a properly trimmed eave detail.
Contact
Conklin today for a FREE estimate regarding our exclusive
line of Pac Clad, Pac-Clad
Colors, Snap-Clad, Tite-Loc,
Tite-Loc Plus, Tite-Loc
HS, Snap-On Standing Seam,
High Snap-On Standing Seam,
Snap-On Batten, Redi-Roof
Standing Seam, Integral
Standing Seam, Integral Batten,
Edge-Loc, 7.2
Panel, 1/2" &
7/8" Corrugated, R-41 &
R-36 Panels, Snow Guards and Pac
Solar Series
|
