 Redi-Roof
Standing Seam
Redi-Roof is an architectural metal roofing system
available exclusively from Petersen Aluminum Corporation. It is intended
for application over a solid substrate with a minimum 3:12 roof pitch.
Typical underlayments include plywood, nailboard insulation or equal.
Panels are to be factory roll-formed in continuous lengths. Maximum
panel length is 45 feet and minimum panel length is 4 feet.
Redi-Roof Panels feature an offset profile which adds
strength and allows room for a hex head fastener. The clip, with its
button punched design, insures an extra-snug fit. The one-piece design
of the Redi-Roof Standing Seam allows for ease of installation.
Trim
All flashing and trim will be fabricated by manufacturer or qualified
fabricator. Flashing shall be PAC-CLAD aluminum (.032-.063 gauge as
specified) or PAC-CLAD steel (22 ga. or 24 ga. as specified). A 20 year
warranty can be supplied covering finish performance.
Installation
Redi-Roof Panels shall be installed over solid decking
with an underlayment of 30# (min.) roofing felt applied horizontally
from eave to ridge. Panels shall be fastened using Petersen non-penetrating
clips, fastening on 18” centers (max.). Minimum slope at 3:12
pitch. Redi-Roof Batten panels cannot be lapped in the field. Consult
a local architect/engineer for requirements of local codes and conditions.
Contact
Conklin today for a FREE estimate regarding our exclusive
line of Pac Clad, Pac-Clad
Colors, Snap-Clad, Tite-Loc,
Tite-Loc Plus, Tite-Loc
HS, Snap-On Standing Seam,
High Snap-On Standing Seam,
Snap-On Batten, Redi-Roof
Standing Seam, Integral
Standing Seam, Integral Batten,
Edge-Loc, 7.2
Panel, 1/2" &
7/8" Corrugated, R-41 &
R-36 Panels, Snow Guards and Pac
Solar Series
|
