 Integral
Standing Seam
PAC-CLAD Integral Standing Seam Panels are designed
for roofing applications, mansards, canopies and fascia. The one-piece
design of the Integral Panels minimizes labor and allows for quick and
easy installation. Integral panels are to be factory roll formed in
continuous lengths. Maximum panel length is 45 feet and minimum panel
length is 4 feet.
Standard on-center dimensions are 11”, 18”
and 19”, but for renovation projects or additions, on-center dimensions
may be custom matched to your requirements. Neoprene panel closures
are available for installation at the eave.
Fasteners
For roofing applications, use Petersen non-penetrating clips. Clips
shall be 606l-T6 extruded aluminum, fastened on 18” centers. Use
wood-type screws in fastening clips. For fascia and mansard applications,
panels should be positively fastened to the substrate.
Trim
All flashing and trim will be fabricated by manufacturer or qualified
fabricator. Flashing shall be PAC-CLAD aluminum (.032-.063 gauge as
specified) or PAC-CLAD 24 ga. steel. A 20 year warranty can be supplied
covering finish performance.
Installation
Roofing Applications: PAC-CLAD Integral Standing
Seam Panels shall be installed over solid decking (5/8” plywood,
nailboard insulation or equal) with an underlayment of 30# (min.) roofing
felt applied horizontally from eave to ridge. Panels shall be fastened
using Petersen non-penetrating clips, fastened on 18” centers
(max.). Minimum slope at 3:12 pitch. Consult a local architect/engineer
for requirements of local codes and conditions.
Contact
Conklin today for a FREE estimate regarding our exclusive
line of Pac Clad, Pac-Clad
Colors, Snap-Clad, Tite-Loc,
Tite-Loc Plus, Tite-Loc
HS, Snap-On Standing Seam,
High Snap-On Standing Seam,
Snap-On Batten, Redi-Roof
Standing Seam, Integral
Standing Seam, Integral Batten,
Edge-Loc, 7.2
Panel, 1/2" &
7/8" Corrugated, R-41 &
R-36 Panels, Snow Guards and Pac
Solar Series
|
